EXPAND THAT MOTHERBOARD
This PCB connects to the motherboard side of the LCD mezzanine connector on the Blackmagic Pocket 4K. It is one of three parts needed to complete the entire LCD extension system. The other components are the LCD-side extension and the jumper wire cable harness. Or you can purchase the whole set HERE.
Compatibility
This kit is compatible with the Pigeon 3.0 naked cage design. Please refer to the installation instructions below on how to install the system.
If you own a V1 Le Pigeon cage with red 15mm standoffs, this may be too low profile and you may need to source some 20mm standoffs to allow additional clearance for the PCB extension adapter and also source 6X 20mm M2 socket head screws, as well as 6X M2 nylock nuts and some 1/8" x 1/16" silicone tubing to act as a spacer/damping. If you have the Pigeon 3.0 cage, you already have these parts.
Specifications
- Rigid 1mm PCB construction
- 80-pin connectors with 10,000 mating cycles
- Low RF interference and improved signal integrity
Includes
- 1X LCD Jumper Cable
- Additional mounting hardware
Installation Instructions
Follow the guide below to properly install your upgrade LCD extension kit for proper fit and function:
The PCB extension adapter comes with a 3D printed shoulder washer/spacer and stainless steel washer plus hex nut. These are necessary for locking the PCB rigidly to the camera motherboard without putting stress on either PCB, but ensuring that the adapter stays connected and secured to the main camera board.
Follow the video instructions below at time code 1:25:58 to see how to install the motherboard extension properly: